Home > Actuators by Model > T16




The T16
linear track actuator
lineup are complete, self-contained linear motion devices with position feedback for sophisticated position control capabilities,
or end of stroke limit switches for simple two position automation. Several gear ratios are available to give you varied speed/force configurations.
The track design makes the T16 significantly shorter than the same stroke length P16, since instead of an extending shaft, a sliding mount is provided.
The sliding mount also significantly increases the maximum side load specification. Premium components in this model include: large sealed stainless steel bearings, planetary gearbox, stainless steel lead screw, and glass re-enforced nylon housing.

P Series: The “P” series linear track actuators offer no built-in controller, but does provide analog position feedback
signal that can be input to an external controller. The “P” series can be used with our Linear Actuator Control Board (LAC)
to give the “P” series the ability to be controlled with USB (via our Configuration Utility Software), 0-5v, 4-20mA, RC Servo or PWM.
On board adjustment of speed, sensitivity and stroke limits are available via the LAC. The “P” series are available in 12v only.

S Series: The "S" series linear track actuators have end of stroke limit switches to that will turn off the unit if it runs into its end stop.
These can be run with a DPDT switch, relay or for RC a you can use a brushed reversible DC motor controller. The T16 “S” series is available in 12v only.